• The outer surface of the device has been produced of galvanized sheet with electrostatic paint resistant to rust and the inner surface is produced of stainless steel sheet.
• Operates with 195-230 V/50 Hz network voltage.
• The door of the device has double thermal glazing, it can be locked and has magnetic seal rings. Thus, it provides an opportunity to trace the stocks. The deep freezer door section has polyurethane insulated block-door system.
• There is a plastic covered wire shelves in the device that can be adjusted according to the desire of the user. The deep freezer section has Cr-Ni shelves system.
• Refrigerator section operates between 0/+15°C and it is set to +4°C. The deep freezer section operates between -10°C/-30°C and it
  is set to -20°C.
• Provides equal temperature distribution with the strengthened fan system it contains.
• Works smoothly and quitely.
• The lightening of the inner cabin of the device is carried out with LED lightening.
• A user-friendly digital control panel with a micro processor has been used on the device. This system can keep the data in memory for 30 days.
• There is a USB Output which has got 10 years recording memory that provides the transmission of the device temperature information to electronic environment if required.
• The thermostat at the control panel of the device can make measurements with 0.1 degree sensitivity.
• There is an accumulator system charged automatically at the control panel of the device. This system provides that at possible electricity cut off­s the digital control panel and the thermal printer continue working for 24  hours.
• While the refrigerator is working, the device gives alerts with the visual and audio signal when the lower and upper temperature limits are exceeded, the door of the device is left open, and there is electricity cut o­ff or low voltage problems.
• The cooling system and the insulation system of the device do not contain CFC gas that is harmful for OZONE.
• There are two braked and two regular castors on the device that provide easy portability.
• As per the request of the user, a thermal printer can be installed at the device. The numerical and graphical printout of the data recorded with the thermal printer can be taken.
• All our products are produced in line with the ISO 9001:2015, TSE service place competence certificates. The device has CE certificate and barcode.

Add to cart